Trouble getting the light strip P34 coming out of O3. Instructions say to go under the board but there is no hole to get there. If it stays on the surface, will it get in the way later?
1 Like
Is it posible to upload a photo? I made the pinball, but i’m on Holliday so can’t open the look in the instructions manual 
Mine has a hole. It has to go underneath the board. Welcome to the group. Can you share a photo of your board?
1 Like
It must go under the board then back up. There is a hole for this process step. Review your build and figure out how or what is covering up the access.
Can you upload photos or videos? May be we help you.
